11 22 500 Removing and installing or replacing flywheel (N14)
WARNING: This page is about a different variant/trim than selected.
Necessary preliminary tasks:
- Remove transmission . See AUTOMATIC TRANSMISSION - COOPER (R57) or MANUAL TRANSMISSION -- REPAIR - COOPER (R57) .
- Remove CLUTCH .
Lock flywheel with special tool 11 9 590 .
Flywheel for automatic transmission
Release flywheel bolts (1).
Tightening torque: 11 22 1AZ.
Installation:
Flywheel is secured with a dowel pin.
Fit new flywheel screws.
Clean crankshaft thread for flywheel screws.
Flywheel for manual gearbox
Flywheel with and without dual-mass: release flywheel bolts (1).
Tightening torque: 11 22 2AZ. .
Installation:
Flywheel is secured with a dowel pin.
Replace flywheel bolts (1).
Clean crankshaft thread for flywheel screws.
Installation:
Sensor gear (1) is loose on crankshaft and is first secured to flywheel.
Dowel pin (2) for securing sensor gear/flywheel.
Assemble engine.