72 11 097 Removing and installing/replacing rear center lower belt fitting
WARNING: This page is about a different variant/trim than selected.
Necessary preliminary tasks:
- Remove rear seat . See SEATS - REPAIR INSTRUCTIONS -- S CLUBMAN .
Installation:
- Microencapsulated screws (Loctite) must be replaced and may not be reused
- Screw connection must be completed within 20 mins. (start of curing)
- Microencapsulated screws must not be retightened
- Clean thread of nut beforehand in event of repeated use
Lift off cover.
Release screw.
Installation:
Replace screw.
Tightening torque 72 11 8AZ .
Remove lower belt fitting.