65 83 570 Removing and installing/replacing CD drive for Car Communication Computer
WARNING: This page is about a different variant/trim than selected.
Special tools required:
- 64 1 020 . See HEATING AND AIR CONDITIONING - SPECIAL TOOLS -- S CLUBMAN
IMPORTANT:
Read and comply with notes on protection against electrostatic damage (ESD protection)!
See 61 35... NOTES ON ESD PROTECTION (ELECTRO STATIC DISCHARGE)
.
Necessary preliminary tasks:
If necessary, cut through warranty seal.
Raise cover (1) with special tool 64 1 020 all round and remove from Car Communication Computer (2).
Release screws (1).
Feed CD drive (2) in direction of arrow out of Car
Communication Computer (3) and set down.
Installation:
Ensure correct routing of cables.
Release screws (1).
Remove CD drive trim (2) in direction of arrow from CD drive (3).
Installation:
Ensure correct routing of cables.
Cut through warranty seal (1) at marked point.
Release screw (2).
Lift side cover out of mounting (3) and carefully place to one side.
Disconnect plug connection (1) and remove CD drive.
Installation:
Ensure correct routing of cables.