63 12 010 Removing and installing or replacing left headlight (xenon headlight)

WARNING: This page is about a different variant/trim than selected.

WARNING: Version with xenon headlights: Danger to life due to high voltage! Therefore, before removing, disconnect all components from the power supply (lighting system and ignition off).
Work on the entire xenon lighting system (ignition unit, control unit and lamp) may only be carried out by specialist personnel.
Follow instructions for handling light bulbs (exterior lights ).

IMPORTANT: Read and comply with notes on protection against electrostatic damage ((ESD) PROTECTION .

Release screws (1). Tightening torque 63 12 1AZ .

Disconnect plug connection (2).

Pull headlight forwards slightly and detach hose connection (3) from high-pressure nozzle (4).

Remove headlight.

Fig 1: Identifying Screws, Plug Connection, Hose Connection And High-Pressure Nozzle

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Adjust gap dimensions by means of adjusting screws (1)
Adjust headlight

Fig 2: Identifying Headlight Adjusting Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Modify xenon bulb for headlight .
Modify bulb for direction indicator .
Modify control unit for xenon headlights .
Modify high-pressure nozzle of headlight washer system. See 61 67 083 REMOVING AND INSTALLING / REPLACING LEFT OR RIGHT HIGH-PRESSURE NOZZLE OF HEADLIGHT WASHER SYSTEM .
Modify adjusting screws.