61 62 062 Removing and installing/replacing left rear window wiper motor
WARNING: This page is about a different variant/trim than selected.
Necessary preliminary tasks:
- Remove wiper arm for rear window wiper .
- Remove trim panel on splitdoor . See 51 49 040 REMOVING AND INSTALLING/REPLACING TRIM PANEL FOR LEFT SPLITDOOR .
Disconnect plug connection (1).
Release wiring harnesses from attachment points (3).
Release screws (2). Tightening torque 61 21 2AZ .
Detach rear window wiper motor (4) from grommet in splitdoor.
Installation:
- Check grommet of wiper shaft for signs of damage, replace if necessary
- Make sure grommet and spacer sleeves (5) are correctly seated on splitdoor and on rear window wiper motor (4) respectively