51 41 005 Removing and installing (replacing) left or right door trim panel carrier

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks:

Disconnect plug connection (1).

Installation:

Check function.

If necessary, initialize power window unit. See 67 62... NOTES ON INITIALIZING POWER WINDOW .

Fig 1: Identifying Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (3) and remove holder (4).

Fig 2: Feed Out Window Cavity Seal At Front (1) And Rear (2) From Door

Courtesy of BMW OF NORTH AMERICA, INC.

Release nut (1) and remove retaining plate underneath.

Release screws (2, 3 and 4).

Tightening torque 51 41 2AZ.

Release carrier (5) from door and pull upwards slightly.

Fig 3: Identifying Carrier, Screws And Nut

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip Bowden cable holder (1) in direction of arrow.

Installation:

Make sure Bowden cable (2) is correctly seated on holder (1).

Make sure Bowden cable is correctly positioned on door trim panel carrier.

Feed out complete door trim panel from door.

Fig 4: Identifying Bowden Cable Holder

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

All-round door seal (1) must not be damaged.

US national variant only:

Crashpad (2) must be fitted.

Fig 5: Identifying All-Round Door Seal And Crash Pad

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement: