41 62 010 Removing and installing left splitdoor

WARNING: This page is about a different variant/trim than selected.

Refer to relevant service information in BODY, GENERAL .

Necessary preliminary tasks:

Release holder (1) in direction of arrow and carefully pull out.

Fig 1: Releasing Holder In Direction Of Arrow

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect both plugs (1) and detach plug from holder (2).

Fig 2: Identifying Plugs And Holder

Courtesy of BMW OF NORTH AMERICA, INC.

Release wiring harness (1) from body and carefully feed out.

Installation:

Make sure wiring harness is correctly seated (watertightness).

IMPORTANT: Secure door against falling out.

Release screws and pull out of hinges.

Tightening torque 41 62 1AZ

Remove door.

Installation:

If necessary, ADJUST DOOR .

Fig 3: Locating Wiring Harness

Courtesy of BMW OF NORTH AMERICA, INC.