41 63 003 Replacing cover bowl

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks:

Remove SERVODRIVE FOR TANK FILLER FLAP .
Remove REAR LEFT WHEEL ARCH TRIM .
Remove FLAP FOR FUEL FILLER NECK .

NOTE: Carry over schematic representation to the relevant vehicle type.

IMPORTANT: Deformation of the sheet metal flanges in the side panel and the wheel arch results in permanent vehicle leakage. Carry out removal/installation with great care.

Cover bowl (1)

Fig 1: Identifying Cover Bowl

Courtesy of BMW OF NORTH AMERICA, INC.

MINI COOPER S:

Unclip tank cap (1) and remove.

Fig 2: Identifying Tank Cap

Courtesy of BMW OF NORTH AMERICA, INC.

MINI COOPER S:

Installation note:

Catches (1) must not be damaged

Fig 3: Identifying Catches

Courtesy of BMW OF NORTH AMERICA, INC.

Release nuts (1) and (2) on fuel filler pipe.

Tightening torque 16 11 1AZ

Installation note:

Make sure ground cable (3) to connected to mounting.

Fig 4: Ensure Ground Cable Is Connected To Mounting

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Illustrations shows fuel filler pipe removed.

Release rubber seal from sheet metal flange.

Fig 5: Releasing Rubber Seal From Sheet Metal Flange

Courtesy of BMW OF NORTH AMERICA, INC.

Turn sleeve (1) through approx. 45° and pull out in direction of arrow.

Fig 6: Turning Sleeve

Courtesy of BMW OF NORTH AMERICA, INC.

Press retaining strap (1) inwards and lift out (see arrow in illustration).

Remove cover (2).

Pierce cover bowl at markings (3) with a small screwdriver.

Fig 7: Pressing Retaining Strap Inwards

Courtesy of BMW OF NORTH AMERICA, INC.

Insert screwdriver to a depth of max. 5 mm and unlock cover bowl catch.

Fig 8: Unlocking Cover Bowl Catch

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock catches (1) and (2) in succession.

Lever out cover bowl in area (3) with plastic wedge.

IMPORTANT: Do not damage sheet metal flange of side panel.

Fig 9: Unlocking Catches And Lever Out Cover Bowl In Area

Courtesy of BMW OF NORTH AMERICA, INC.

Carefully turn cover bowl (1) in direction of arrow and remove.

Installation note:

Open hinge arm.

Insert cover bowl and engage sealing sleeve over fuel filler pipe.

Fig 10: Identifying Cover Bowl Angle

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Using fitting aid (1), pull sealing lip (2) over sheet metal flange of wheel arch (3).

Fig 11: Pulling Sealing Lip Over Sheet Metal Flange Of Wheel Arch

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Illustrations shows fuel filler pipe removed.

Check that sealing lip is correctly seated.

Fig 12: Locating Sealing Lip

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Cover bowl must snap into place 3 times.

After installing, carefully check that cover bowl is securely seated.

There must be no discernible gap between sealing lip and side panel in area (1).

Fig 13: Identifying Sealing Lip And Side Panel Area

Courtesy of BMW OF NORTH AMERICA, INC.