36 10 713 Checking one road wheel on balancing machine for face and radial runout (wheel removed)
WARNING: This page is about a different variant/trim than selected.
Special tools required:
- 36 1 030 . See WHEEL AND TIRES - SPECIAL TOOLS -- S CLUBMAN .
- 36 1 031
- 36 1 032
- 36 1 033
- 36 1 034
- 36 1 035
- 36 1 036
Necessary preliminary tasks:
- Remove wheel
Mount wheel in balancing machine.
To avoid retooling errors, fit the wheel on the balancing machine in the same way as it is also fitted on the car (valve position facing down).
Use suitable wheel centering element supplied with corresponding balancing machine.
- Basic flange
- Wheel centering element
- Type flange
- Clamping nut
Also refer to WORKSHOP EQUIPMENT .
Use special tool 36 1 030 for testing.
Special tool 36 1 030 consists of:
- Stand 36 1 031
- Post with clamp 36 1 032
- Holder with clamp 36 1 033
- Clamp 36 1 034
- Measuring roller 36 1 035
- Dial gauge 36 1 036
Position special tool 36 1 030 on tire tread.
Turn wheel by hand and measure max. radial tire runout. See 36 10 WHEELS .
NOTE:
Measuring device must be vertical to tire tread.
Position special tool 36 1 030 on tire side wall.
Turn wheel by hand and measure max. lateral tire runout. See 36 10 WHEELS .
NOTE:
Measuring device must be vertical to tire side wall.
Never measure on printed text on tire!
If necessary, check disc wheel (rim) for radial and face runout. See 36 10 WHEELS .
Never measure on printed text on tire!
If necessary, check disc wheel (rim) for radial and face runout. See 36 10 WHEELS .