LEMON Manuals: Even more car manuals for everyone
Home >> Mini >> 2010 >> Cooper S, 2D Hatchback, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 974 (Engine - Repair (N62)) >> Pistons With Rings And Pin >> 11 25 530 Removing and installing/replacing all pistons (N62) >> Cylinder bank 5 to 8

Cylinder bank 5 to 8

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2005 BMW 745i, 2005 BMW 745Li, 2004 BMW 745i, 2004 BMW 745Li, and 2003 BMW 745i. However, it is still accessible from the selected car via links, so may be relevant.

Fit conrod with piston pin to piston in such a way that arrow on piston points to front and flat end of conrod points to rear.

Fig 1: Fitting Conrod With Piston Pin To Piston
G03288851Courtesy of BMW OF NORTH AMERICA, INC.

Install conrod bearing. Refer to 11 24 571 Replacing all conrod bearings (N62) .

Install retaining ring.

Fig 2: Installing Retaining Ring
G03288852Courtesy of BMW OF NORTH AMERICA, INC.

Insert special tools 11 8 151 and 11 8 152 in conrod.

Fig 3: Inserting Special Tools In Conrod
G03288853Courtesy of BMW OF NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals