12 14 537 Replacing camshaft pulse generator

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2008 MINI Cooper, 2007 MINI Cooper, 2006 MINI Cooper, 2005 MINI Cooper, and 2004 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Switch off ignition
Read out fault memory of DME control unit
Check stored fault messages
Remove right engine support arm, refer to 22 11 100 REPLACING RIGHT ENGINE MOUNTING BRACKET (FROM 12.03) or 22 11 100 REPLACING RIGHT ENGINE MOUNTING BRACKET (UP TO 12.03)

Unlock and disconnect pulse generator plug.

Fig 1: Removing Pulse Generator

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1), remove pulse generator (2).

Installation:

Replace sealing ring and coat with antiseize agent.

Tightening torque 13 62 1AZ. Refer to FUEL SUPPLY SYSTEM - TIGHTENING TORQUES .

NOTE: Now clear the fault memory.