67 11 555 Removing and installing/replacing servodrive for tank filler flap

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2008 MINI Cooper, 2007 MINI Cooper, 2006 MINI Cooper, 2005 MINI Cooper, and 2004 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.

Necessary Preliminary Tasks:

Remove left rear light. Refer to 63 21 180 REMOVING AND INSTALLING/REPLACING LEFT OR RIGHT REAR LIGHT .

Unlock catches (1) and remove cover (2).

Fig 1: Identifying Catches In Cover

G03307281

Courtesy of BMW OF NORTH AMERICA, INC.

Unfasten plug connection (1) and disconnect.

Release screw (2).

Slide servodrive for tank filler flap (3) upwards slightly and feed towards rear out of retaining plate.

Installation:

Make sure plastic retainer (4) is correctly seated in retaining plate.

Fig 2: Removing Plug Connection

G03307282

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Carry out feed-in operation through rear light opening in rear side panel.

Insert servodrive for tank filler flap (1) with locking pin (2) into gaiter (3).

Fig 3: Installing Servodrive For Tank Filler Flap

G03307283

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Unclip emergency actuator (1) in direction of arrow from servodrive for tank filler flap (2).

Fig 4: Identifying Emergency Actuator

G03307284

Courtesy of BMW OF NORTH AMERICA, INC.