11 00 Mounting Engine On Assembly Stand (N63O1)

WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2018 BMW M6, 2018 BMW 650i xDrive, 2018 BMW 650i, 2018 BMW 640i xDrive, and 2018 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

WARNING:

Remove engine with hoist and special tool 11 0 020 .

Fit special tool 11 8 930 on engine.

Engine weighs approx. 280 kg.

Necessary preliminary tasks:

- Fully remove front axle together with engine.

- Remove engine from front axle. See applicable procedure for drivetrain configuration: REMOVING AND INSTALLING ENGINE ON FRONT AXLE (N63O1) WITH GA8HP70Z TRANSMISSION , REMOVING AND INSTALLING ENGINE ON FRONT AXLE (N63O1) WITH GA8HP70Z ALL-WHEEL DRIVE VEHICLE TRANSMISSION , REMOVING AND INSTALLING ENGINE ON FRONT AXLE (N63O1) WITH GA6HP26Z ALL-WHEEL DRIVE VEHICLE TRANSMISSION or REMOVING AND INSTALLING ENGINE ON FRONT AXLE (N63O1) WITH MANUAL GEARBOX .

- Clean contact surfaces.

Use special tool 11 8 931 to mount special tool 11 8 932 .

Insert screws (1 and 2).

Tightening torque: 11 11 9AZ .

Fig 1: Identifying Special Tool And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Use special tool 11 8 931 to mount engine on special tool 00 2 300 .

Tightening torque: 11 11 10AZ

Illustration shows engine N63.

Fig 2: Mounting Engine On Assembly Stand

Courtesy of BMW OF NORTH AMERICA, INC.