51 21 300 Removing and installing or replacing window cavity cover strip on outside of left or right front door
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2016 BMW 328i xDrive, 2016 BMW 328d xDrive, 2015 BMW 328i xDrive, 2015 BMW 328d xDrive, and 2014 BMW 328i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
IMPORTANT:
Weather strip in plastic design cannot be removed without damage.
Observe PROCEDURE for using special tool 00 9 324 .
The "INSTRUCTIONS ON FITTING WINDOW GUIDE SEALS " serve as the basis for this repair instruction and must be observed without fail.
Observe PROCEDURE for using special tool 00 9 324 .
The "INSTRUCTIONS ON FITTING WINDOW GUIDE SEALS " serve as the basis for this repair instruction and must be observed without fail.
Necessary preliminary tasks:
- Remove MIRROR ON FRONT DOOR
IMPORTANT:
If reusing the existing window cavity cover strip (1), make sure it is not bent.
Lever out weather strip (1) with special tool 00 9 324 (starting at B-pillar).
At the same time, pry out weather strip (1) carefully using special tool 00 9 325 in the area of the B-pillar cover.
Installation note:
Moisten weather strip (1) prior to installation with APPROVED LUBRICANT .