11 13 000 Removing and fitting, sealing or replacing the oil sump (N20 all-wheel drive vehicle)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2016 BMW 328i xDrive, 2016 BMW 328d xDrive, 2015 BMW 328i xDrive, 2015 BMW 328d xDrive, and 2014 BMW 328i xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Drain and add ENGINE OIL .
Remove FRONT AXLE DIFFERENTIAL .
Remove BEARING SUPPORT .

Fig 1: Engine Oil Pipe Brackets And Screws
Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection on oil level sensor.

Release screws (1) and remove brackets for engine oil pipe.

Release bolts along line (2).

Tightening torque: 11 13 4AZ

If applicable, remove or reposition oil level sensor.

Tightening torque: 11 13 7AZ .

If applicable, remove or reposition bearing support.

Installation note:

Replace O-ring.

IMPORTANT: There must be no adhesive residues in the lower crankcase section retaining threads.
Clean retaining threads and sealing surfaces.

Installation note:

Replace gasket (1).

Fig 2: Oil Sump Gasket

Courtesy of BMW OF NORTH AMERICA, INC.

Assemble engine.