31 53 040 Removing and installing/replacing right output shaft bearing block

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2016 BMW 328i xDrive, 2016 BMW 328d xDrive, 2015 BMW 328i xDrive, 2015 BMW 328d xDrive, and 2014 BMW 328i xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

REMOVE right output shaft.
Release sound insulation of oil sump if necessary.

Release screws (1).

Tightening torque 31 60 1AZ .

Remove bearing support from oil sump.

Installation note:

Replace O-RING .

Fig 1: Identifying Output Shaft Bearing Block Screws

Courtesy of BMW OF NORTH AMERICA, INC.