21 52 500 Removing and installing/replacing clutch master cylinder

WARNING: This page does not describe the selected car, but rather 27 other vehicles, including the 2017 BMW M6, 2017 BMW 650i xDrive, 2017 BMW 650i, 2017 BMW 640i xDrive, and 2017 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: After completing work, bleed CLUTCH HYDRAULIC SYSTEM .

Necessary preliminary work:

Remove BEARING SUPPORT for foot pedal

Release screws (1).

Take off holder (2).

Fig 1: Identifying Holder And Screws

G09915456

Courtesy of BMW OF NORTH AMERICA, INC.

Undo bolts (1) and (2).

Installation note:

Renew bolts (1) and (2).

Remove clutch master cylinder (3).

Fig 2: Identifying Clutch Master Cylinder And Bolts

G09915118

Courtesy of BMW OF NORTH AMERICA, INC.

Detach supply hose (1) from clutch master cylinder.

Fig 3: Identifying Supply Hose And Clutch Master Cylinder

G04725961

Courtesy of BMW OF NORTH AMERICA, INC.

Lever clutch switch (1) out of clutch master cylinder (2) with a screwdriver.

Fig 4: Removing Clutch Switch Of Master Cylinder

G04725962

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

The clutch switch is secured against incorrect installation.

The clutch switch must snap audibly into place.

Fig 5: Identifying Clutch Switch

G04725963

Courtesy of BMW OF NORTH AMERICA, INC.