12 51 301 Removing and installing/replacing engine wiring harness section, ignition module cylinder 5-8 (N63)

WARNING: This page does not describe the selected car, but rather 27 other vehicles, including the 2017 BMW M6, 2017 BMW 650i xDrive, 2017 BMW 650i, 2017 BMW 640i xDrive, and 2017 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) .

IMPORTANT: Screw back on all screw points of cable channels without fail! Some screw points are also ground points.
If the wiring harnesses are not correctly screwed tight and secured, this may cause DME malfunction and failure!

Necessary preliminary tasks:

Read out the fault memory of the DME control unit.
Switch off ignition.
Remove left SUSPENSION CROSS-BRACE .
Remove left INTAKE FILTER HOUSING

Fig 1: Overview Of Engine Wiring Harness Section
Courtesy of BMW OF NORTH AMERICA, INC.

Overview of engine wiring harness section, ignition module cylinder 5-8.

Unlock all connectors from ignition coils and injectors and detach.

Release screws (1).

Tightening torque 12 51 2AZ .

IMPORTANT: Screw back on all screw points of cable channels without fail. Some screw points are also ground points.

Fig 2: Identifying Screws

Courtesy of BMW OF NORTH AMERICA, INC.

If fitted:

Unscrew nuts (1).

Detach ground connections.

Fig 3: Identifying Nuts

Courtesy of BMW OF NORTH AMERICA, INC.

Release wiring harness if necessary from existing clips and clamps.

Feed out wiring harness and remove.

Installation note:

Check wiring harness installation arrangement.

Check plug connections for correct fit.

Check stored fault message.

Clear diagnostic fault entries from fault memory.