51 71 346 Removing and installing/replacing right (rear) suspension cross-brace
WARNING: This page does not describe the selected car, but rather 27 other vehicles, including the 2017 BMW M6, 2017 BMW 650i xDrive, 2017 BMW 650i, 2017 BMW 640i xDrive, and 2017 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Driving without the suspension cross-brace is not permitted. (risk of damage to the body).
Release expanding rivets (1) and remove cover (2).
Installation note:
Replace damaged expanding rivet.
Holder of cover (2) must snap into place in suspension cross-brace during installation.
Release screws (1).
Tightening torque 51 61 1AZ .
Remove suspension cross-brace (2).
Installation note:
Make sure suspension cross-brace (2) is in correct installation position.
Replace screws (1).