64 11 545 Removing and installing fan housing for heater/air conditioner (N52T, N55)

WARNING: This page does not describe the selected car, but rather 27 other vehicles, including the 2017 BMW M6, 2017 BMW 650i xDrive, 2017 BMW 650i, 2017 BMW 640i xDrive, and 2017 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Disconnect BATTERY EARTH LEAD
Remove RIGHT/REAR SUSPENSION CROSS-BRACE

Release screws (1).

Tightening torque 12 90 4AZ .

Remove lid (2) for additional electronics box toward the top.

Fig 1: Identifying Lid Screws

G09929261

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock and disconnect all plug connections.

Unlatch connector housing (1 and 2) from guide of auxiliary E-box (3).

Fig 2: Locating Auxiliary E-Box Connector Housing

G09875482

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock plug connection (1) on automatic air recirculation control sensor (2) and disconnect.

Fig 3: Identifying Automatic Air Recirculation Control Sensor Plug Connection

G06886157

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Picture without supplemental electronics box.

Release screws (1) on blower housing cover (2).

Lift out blower housing cover.

Fig 4: Identifying Blower Housing Cover Screws

G06886158

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) on fan housing (2).

Unlock plug connections (3) and disconnect.

Carefully feed out fan housing (2).

Fig 5: Identifying Fan Housing Screws And Plug Connections

G06886159

Courtesy of BMW OF NORTH AMERICA, INC.