64 11 545 Removing and installing blower housing for heating and air-conditioning unit

WARNING: This page does not describe the selected car, but rather 27 other vehicles, including the 2017 BMW M6, 2017 BMW 650i xDrive, 2017 BMW 650i, 2017 BMW 640i xDrive, and 2017 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove RIGHT/REAR SUSPENSION CROSS-BRACE
REMOVE auxiliary electronics box

Unlock plug connection (1) on automatic air recirculation control sensor (2) and disconnect.

Fig 1: Identifying Automatic Air Recirculation Control Sensor Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) on blower housing cover (2).

Lift out blower housing cover.

Fig 2: Identifying Blower Housing Cover Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) on fan housing (2).

Unlock plug connections (3) and disconnect.

Carefully feed out fan housing (2).

Fig 3: Identifying Fan Housing Screws And Plug Connections

Courtesy of BMW OF NORTH AMERICA, INC.