64 12 570 Replacing turbocharger coolant pump for auxiliary heating
WARNING: This page does not describe the selected car, but rather 27 other vehicles, including the 2017 BMW M6, 2017 BMW 650i xDrive, 2017 BMW 650i, 2017 BMW 640i xDrive, and 2017 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Risk of burning!
Repair work on the cooling system may only be carried out when it has cooled down.
Repair work on the cooling system may only be carried out when it has cooled down.
Recycling
Coolant emerges when coolant lines are detached. Have a suitable collecting vessel ready.
Catch and dispose of emerging coolant.
Observe country-specific waste disposal regulations.
NOTE:
Clamp off COOLANT HOSES .
Necessary preliminary work:
- Remove FRONT UNDERBODY PROTECTION
- Remove FRONT BUMPER PANEL
NOTE:
Graphic similar.
Release screws (1).
Remove lower left cover (2).
Unfasten plug connection (1) and disconnect.
Release spring clamps (2) and detach coolant hoses.
Release screw (3) and remove retaining bracket.
Remove turbocharger coolant pump (4).
After installation: