72 12 050 Removing and installing side airbag (front seat)
WARNING: This page does not describe the selected car, but rather 27 other vehicles, including the 2017 BMW M6, 2017 BMW 650i xDrive, 2017 BMW 650i, 2017 BMW 640i xDrive, and 2017 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Operations on pyrotechnical devices may only be carried out by authorized experts.
Improper, unauthorized operations may result in serious dangers.
Unauthorized persons are strictly prohibited from performing any operations on this system.
Improper, unauthorized operations may result in serious dangers.
Unauthorized persons are strictly prohibited from performing any operations on this system.
WARNING:
Observe SAFETY REGULATIONS for handling airbag modules and pyrotechnical seat belt tensioners.
Incorrect handling can activate airbag and cause injury.
A damaged airbag must be replaced because its protective function is compromised and, in an extreme situation, it can no longer execute its protective function.
Incorrect handling can activate airbag and cause injury.
A damaged airbag must be replaced because its protective function is compromised and, in an extreme situation, it can no longer execute its protective function.
Installation note:
- Microencapsulated screws (Loctite) must be replaced and may not be reused
- Screw connection must be completed within 20 minutes (start of curing)
- Microencapsulated screws must not be retightened
- Clean thread of nut beforehand in event of repeated use
Necessary preliminary tasks:
- Disconnect BATTERY NEGATIVE CABLE
- Remove BACKREST COVER ON THE OUTSIDE OF THE FRONT SEAT
Release screws (1).
Remove airbag module (2) in direction of arrow.
Installation note:
Replace screws.
Tightening torques 72 12 06AZ .
Airbag module is coded against incorrect assembly.
Unlock PLUG CONNECTION (1) and disconnect.