67 10 522 Replacing (removing and installing) the drive unit for rear view camera

WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2018 BMW M6, 2018 BMW 650i xDrive, 2018 BMW 650i, 2018 BMW 640i xDrive, and 2018 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) .

Necessary preliminary tasks:

Remove trim for rear lid. See 51 49 000 REMOVING AND INSTALLING OR REPLACING TRIM FOR REAR LID .

Unlock plug connections (3) and (4) and disconnect.

Release screws (1) and (2).

Remove drive unit (5).

Fig 1: Removing Drive Unit For Rear View Camera

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

The operation emblem (1) must be completely closed when installing the drive unit.

The operating lever (2) on the operating emblem (1) must be connected correctly with the guide in the drive unit.

Fig 2: Identifying Operation Emblem And Lever

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Remount the REAR VIEW CAMERA .