67 11 555 Removing and installing/replacing actuator drive for fuel filler flap

WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2018 BMW M6, 2018 BMW 650i xDrive, 2018 BMW 650i, 2018 BMW 640i xDrive, and 2018 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary work:

Remove cover housing. See 41 63 003 REPLACE COVER BOWL .

Use a suitable tool to unlock the tabs (1) on the front and back.

Remove actuator drive (3) from cover pot (2).

Fig 1: Identifying Actuator Drive, Cover Pot And Tabs

Courtesy of BMW OF NORTH AMERICA, INC.

Release the actuator drive (2) by simultaneously turning and pressing the locking pin (1).

Installation note:

Make sure the setting for the actuator drive (2) for the fuel filler flap is correct. It must be possible to lock or unlock the fuel filler flap completely.

Fig 2: Identifying Actuator Drive And Locking Pin

Courtesy of BMW OF NORTH AMERICA, INC.