22 11 001 Replacing right engine mount (N63) AWD

WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2018 BMW M6, 2018 BMW 650i xDrive, 2018 BMW 650i, 2018 BMW 640i xDrive, and 2018 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Secure engine in installation position . See 11 00 670 SECURING ENGINE IN INSTALLATION POSITION (N63) or 11 00 670 SECURING ENGINE IN INSTALLATION POSITION (N63O1) .
Remove rear underbody protection. See 51 47 491 REMOVING REFITTING/REPLACING REAR ENGINE UNDERCOVER .
Release ENGINE SUPPORT ARM

Release bolt (1) and remove engine mount.

Tightening torque 22 11 2AZ .

IMPORTANT: Installation note:
To ensure play between engine mount and engine support arm, lower the engine completely before tightening the screw connection (engine mount/engine support arm).

Fig 1: Identifying Engine Mount Bolt

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Rubber part (1) of engine mount must point to center of vehicle.

Fig 2: Identifying Rubber Part

Courtesy of BMW OF NORTH AMERICA, INC.