36 10 508 Stationary wheel balancing

Special tools required: 

• 36 1 010
• 36 1 020

Necessary preliminary tasks: 

• Remove WHEEL 

Remove any fitted balancing weights, stones in tire tread and greater soiling.

Check tire pressure, tire condition, damage, flat spots (irregularities caused by, e.g. parking vehicle with overheated tires). Where applicable, check WHEEL AND TIRES  for radial and lateral runout.

Fig 1: Identifying Wheel On Balancing Machine

Courtesy of BMW OF NORTH AMERICA, INC.

Use BMW approved wheel centering for relevant balancing machine manufacturer.

1. Basic flange
2. Wheel centering element
3. Type flange
4. Nut

Fig 2: Identifying Wheel Centering Element, Flange And Clamping Nut

Courtesy of BMW OF NORTH AMERICA, INC.

On light-alloy rims with distinctive J-shape rim flange, proceed as follows:

1. Gently force off tire sidewall with special tool 36 1 020 at appropriate point from rim flange.
2. Install retaining clamp (1).
3. Remove special tool 36 1 020.
   Fig 3: Identifying Retaining Clip And Special Tool 36 1 020

   Courtesy of BMW OF NORTH AMERICA, INC.

Raise retaining clip with special tool 36 1 010. Slide balance weight underneath and allow it to snap into place.

Fig 4: Raising Retaining Clip Using Special Tool 36 1 010

Courtesy of BMW OF NORTH AMERICA, INC.

Arrangement of balance weights for light-alloy rims with distinctive J-shape rim flanges.

1. Spring retainer
2. Balance weight

Adhesive weights must be used on all other light-alloy rims.

Maximum imbalance  . See WHEELS TWO-PART ALLOY WHEELS , WHEELS ONE-PART ALLOY WHEELS or WHEELS STEEL AND ALUMINUM STRIP WHEELS per wheel.

Fig 5: Identifying Spring Retainer And Balance Weight

Courtesy of BMW OF NORTH AMERICA, INC.