66 53 170 Removing and installing/replacing control unit for Top-/Rear-/Side-View Camera

WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2018 BMW M6, 2018 BMW 650i xDrive, 2018 BMW 650i, 2018 BMW 640i xDrive, and 2018 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on protection against electrostatic damage (ESD PROTECTION) .

Necessary preliminary tasks:

Remove left luggage compartment wheel arch panel. See 51 47 151 REMOVING AND INSTALLING/REPLACING LEFT LUGGAGE COMPARTMENT WHEEL ARCH TRIM .

Release screw (1).

Remove amplifier (2) in direction of arrow.

Fig 1: Removing Amplifier

G09928967

Courtesy of BMW OF NORTH AMERICA, INC.

Release nuts (2) and screws (3).

Remove control unit TRSVC (1) including holder.

Fig 2: Identifying Control Unit TRSVC, Nuts, Screws

G09928968

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock plug connections (1) and disconnect.

Replacement:

Unfasten screws (2).

Remove control unit TRSVC (3) from bracket.

Fig 3: Identifying Control Unit TRSVC, Screws, Plug Connections

G09928969

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Carry out PROGRAMMING/ENCODING .
CALIBRATE REVERSING CAMERA