31 35 000 Removing and installing/replacing front anti-roll bar

WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2018 BMW M6, 2018 BMW 650i xDrive, 2018 BMW 650i, 2018 BMW 640i xDrive, and 2018 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove FRONT UNDERBODY PROTECTION .
Remove BOTH ANTI-ROLL BAR LINKS FROM ANTI-ROLL BAR .
All-wheel drive vehicles: remove the FRONT STIFFENING PLATE .
RWD vehicles: remove stiffening plate. See 31 11 040 REMOVING AND INSTALLING/REPLACING STIFFENING PLATE (EXCEPT M6) or 31 11 040 REMOVING AND INSTALLING/REPLACING STIFFENING PLATE (M6) .

Release screws (1).

Tightening torque 31 35 1AZ .

Remove anti-roll bar (2) downwards.

Fig 1: Identifying Anti-Roll Bar Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Fig 2: Locating Retaining Bracket And Mounting Plate

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Replace screws.

Pay attention to installation location of retaining bracket and mounting plate!

Nose (1) on retaining bracket must point left in direction of travel (F)
Curve (2) on lower mounting plate points to rubber bearing