34 21 169 Removing And Installing/Renewing A Brake Anchor Plate/Brake Guard Plate At Rear
WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2018 BMW M6, 2018 BMW 650i xDrive, 2018 BMW 650i, 2018 BMW 640i xDrive, and 2018 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Remove WHEEL BEARING .
Unscrew bolts (1) and remove brake guard plate (2).
Installation note:
Replace screws.
Tightening torque 34 21 3AZ .
Remove retaining plate (2) in direction of arrow.
Feed out brake guard plate (3) over wheel hub.