17 11 370 Removing and installing/replacing cooling loop for power steering
WARNING: This page is about a different car, the 2003 BMW X5 and 2002 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Make sure all parts are absolutely clean.
No dirt is allowed to enter the system.
After installation, bleed power steering.
No dirt is allowed to enter the system.
After installation, bleed power steering.
Recycling: Draw off power steering fluid from supply tank - do not reuse fluid. Observe country-specific waste-disposal regulations.
Disconnect quick-release couplings on hydraulic lines.
Remove radiator. Refer to 17 11 000 REMOVING AND INSTALLING RADIATOR (M62, M54 AND M57) .
Remove cooling coil.