66 53 020 Removing and installing/replacing reversing camera RFK (after 10/2009)

WARNING: This page is about a different car, the 2011 BMW X6 and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) .

Necessary preliminary tasks

Remove TAILGATE UPPER SECTION TRIM PANEL

Unlock holder (1) in direction of arrow.

Remove reversing camera (2).

Replacement

Remove protective film from reversing camera lens.

Fig 1: Identifying Holder And Reversing Camera

Courtesy of BMW OF NORTH AMERICA, INC.

Unfasten plug connection (1) and disconnect.

Remove reversing camera (2).

Fig 2: Identifying Plug Connection And Reversing Camera

Courtesy of BMW OF NORTH AMERICA, INC.

After installation

Calibrate REVERSING CAMERA