51 49 000 Removing and installing or replacing trim for rear lid

WARNING: This page is about a different car, the 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

00 9 317

Necessary preliminary tasks:

Remove PANEL FOR REAR WINDOW FRAME on left and right
Remove LUGGAGE COMPARTMENT LIGHTS ON TAILGATE
Remove button for tailgate actuation on left and right

Fit special tool 00 9 317 on inside of lid (1) and lift out.

Release screws (2) and unclamp panel.

Fig 1: Identifying Rear Lid And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

If necessary, replace faulty clips (1 and 2).

Make sure all clamps are installed in correct position.

Fig 2: Identifying Rear Lid Trim Clips

Courtesy of BMW OF NORTH AMERICA, INC.