66 50 040 Removing and installing/replacing exterior mirror camera

WARNING: This page is about a different car, the 2011 BMW X6 and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks

Remove PROTECTIVE CAP FROM EXTERIOR MIRROR

Release screw (1).

Detach exterior mirror camera (2) from protective cap (3).

Fig 1: Identifying Screw, Exterior Mirror Camera And Protective Cap

Courtesy of BMW OF NORTH AMERICA, INC.

Calibration

Only vehicles with production date up to 10/2009 Mount KDS quick-release clamp on the wheels of the side being calibrated: e.g. front left and rear left.
(Mounting the KDS quick-release clamp identifies the wheel center.)
All vehicles: Calibration is performed via BMW diagnosis system:
- Service function
- Body
- All-round vision camera
- Calibration of all-round vision camera