65 50 570 Replacing rear cabin monitor display

WARNING: This page is about a different car, the 2011 BMW X6 and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) .

Necessary preliminary tasks:

Remove TRIM FOR REAR CABIN MONITOR DISPLAY AT FRONT AND REAR

Disconnect plug connection (1).

Unfasten screws (2).

Tightening torque 64 52 3AZ .

Release screw (3) and remove display (4) towards top.

Tightening torque 65 52 4AZ .

Installation:

Remove protective film from replacement display.

Fig 1: Identifying Plug Connection, Display And Screws

Courtesy of BMW OF NORTH AMERICA, INC.