65 50 160 Removing and installing/replacing trim for rear cabin monitor display at front and rear

WARNING: This page is about a different car, the 2011 BMW X6 and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

00 9 340

IMPORTANT: Trims may only be replaced in pairs so as to avoid differences in color.

Unclamp trims (1) on both sides with special tool 00 9 340

Installation note:

Make sure trims (1) are securely seated in rear cabin monitor trim at front.

Fig 1: Removing Trims On Both Sides With Special Tool 00 9 340

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Tightening torque 65 52 2AZ .

Fig 2: Identifying Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Unclamp trim for display at rear (1) with special tool 00 9 340 and remove.

Fig 3: Unclamping Trim For Display At Rear With Special Tool 00 9 340

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Carefully remove trim for display at front (2) and disconnect plug connection (3).

Installation note:

Make sure ribbon cable is securely seated.

Fig 4: Removing Trim For Display At Front And Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.