65 50 121 Removing and installing rear cabin monitor (complete)

WARNING: This page is about a different car, the 2011 BMW X6 and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) .

Necessary preliminary tasks:

Remove FRESH-AIR GRILLE IN REAR CABIN
Remove TRIM FOR REAR CABIN MONITOR BASE AT FRONT AND REAR

Release screws (1) and remove rear cabin monitor with holder (2).

Disconnect associated plug connections and feed out leads.

Tightening torque 65 52 1AZ .

Fig 1: Identifying Rear Cabin Monitor Holder And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Ensure correct cable routing (1) on both sides.

Fig 2: Identifying Cable Routing

Courtesy of BMW OF NORTH AMERICA, INC.