65 50 150 Removing and installing/replacing trim for rear cabin monitor base at front and rear

WARNING: This page is about a different car, the 2011 BMW X6 and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

00 9 340

IMPORTANT: Trims may only be replaced in pairs so as to avoid differences in color.

Using special tool 00 9 340 , unclamp trim (1) on both sides.

Fig 1: Disconnecting Trim Using Special Tool (00 9 340)

Courtesy of BMW OF NORTH AMERICA, INC.

Unclamp trim (1) for base at front with special tool 00 9 340 and remove.

Fig 2: Disconnecting Trim For Base At Front Using Special Tool (00 9 340)

Courtesy of BMW OF NORTH AMERICA, INC.

Open armrest (1).

Unclamp trim (2) for base at rear with special tool 00 9 340 and feed out.

Fig 3: Disconnecting Trim For Base At Rear With Special Tool (00 9 340)

Courtesy of BMW OF NORTH AMERICA, INC.