65 24 020 Removing and installing/replacing blocking circuit (left or right)

WARNING: This page is about a different car, the 2011 BMW X6 and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Partially remove roofliner in working area. See ROOFLINER (VERSION WITH SLIDE/TILT SUNROOF) or ROOFLINER (VERSION WITHOUT SLIDE/TILT SUNROOF) .

Roofliner shown completely removed for purposes of clarity.

Disconnect plug connections (2).

Release screw (1) and remove blocking circuit (3).

Fig 1: Identifying Plug Connections, Blocking Circuit And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Fit blocking circuit (1) so that screw (2) engages thread (3) and locating pin (4) engages bore (5).

Fig 2: Identifying Blocking Circuit, Thread, Locating Pin And Bore

Courtesy of BMW OF NORTH AMERICA, INC.