63 10... Adjust the low-beam headlight (with electronic headlight adjustment device MAHA Lite 3)

WARNING: This page is about a different car, the 2011 BMW X6 and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Repair instructions apply only to software release from version V 0.78...

Software release is shown for a short time in the display after the device is switched on.

Comply with TEST PREREQUISITES for headlight adjustment!

Refer to the operating instructions for the headlight adjustment device!

NOTE:

On vehicles with anti-glare high-beam headlight it is sufficient to adjust the low-beam headlight.

Only in the event of a customer complaint regarding dazzle/glare: Adjust anti-glare high-beam headlight separately.

Switch on the headlight adjustment device by pressing any button.

Press F2 button. The shown display screen appears.

Perform the following settings:

Passenger car must be selected
Enter the setting dimension of the headlight via the buttons F1/F2: - 1, 0 % to - 1, 1 %
(see "light/dark boundary of the headlight in the headlight adjustment device" in TEST REQUIREMENTS ).
The right/left-hand traffic must be selected according to the country.
Select the headlight type via the button F3:
- EC: for halogen and xenon headlights
- EC LED: for LED headlight

The adjusted values are adopted for future measurements.

Fig 1: Identifying Lamp Settings Display Screen

Courtesy of BMW OF NORTH AMERICA, INC.

Briefly press the button for the applicable side of the vehicle (1) until symbol (2) appears.

The following symbols appear in the display:

O. K. (3): Setting optimal.
O. K. (4): Setting within legally stipulated tolerance range. ADJUST HEADLIGHT until O. K. (3) is displayed.
Arrows (5): Setting incorrect.Using arrows (5) ADJUST HEADLIGHT until O. K. (3) is displayed.

Fig 2: Identifying Symbols In Display

Courtesy of BMW OF NORTH AMERICA, INC.