63 14 120 Removing and installing/replacing rear reflector (rear fog light)
WARNING: This page is about a different car, the 2011 BMW X6 and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Remove REAR BUMPER TRIM
If necessary, disconnect plug connection for rear fog light.
Release screws (1). Tightening torque 63 14 1AZ .
Feed reflector (2) in direction of arrow out of bumper trim (3).
Installation:
Make sure guides (5) of reflector (2) are correctly seated in associated mountings (4) of bumper trim (3).