27 10 020 Installing replacement transfer box (ATC 700)
WARNING: This page is about a different car, the 2011 BMW X6 and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Before After replacement:, execute the "Repair" service function with the BMW diagnosis system.
Recycling:
Catch and dispose of escaping transmission oil. Observe country-specific waste disposal regulations
IMPORTANT:
After completing work, check transmission oil level and top up if necessary.
Release filler plug (1).
Check oil level.
Tightening torque 27 00 11AZ .
Pour in transmission oil up to lower edge of opening for filler plug (1).
Use only approved oil: Transfer-box oil TF0870, BMW part number 83 22 0 397 244 (1-litre can)
Release filler plug (1).
Check oil level.
Tightening torque 27 00 11AZ .
Pour in transmission oil up to lower edge of opening for filler plug (1).
Use only approved oil: Transfer-box oil TF0870, BMW part number 83 22 0 397 244 (1-litre can)
Failure to comply with this requirement will result in serious damage to the transfer box!
Necessary preliminary tasks:
- Drain transmission oil at oil drain plug
Tightening torque 27 00 11AZ .
- Remove TRANSFER BOX
Modify following parts:
- Covers and protective caps
- Drive shaft transportation retainer
- Vent hose of transfer box
- If required, replace RUBBER MOUNT for transmission mounting