22 32 001 Replacing rubber mount for transmission mounting (ATC 700)

WARNING: This page is about a different car, the 2011 BMW X6 and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

22 1 016
22 1 017
22 1 101
22 1 102
22 1 103
33 4 465

Necessary preliminary tasks:

Remove CROSS MEMBER for transmission mounting

Position special tool 22 1 016 at recess (1) and screw in screw (2) hand-tight against housing.

Pull out rubber mount with special tools 22 1 101/33 4 465 and nut 22 1 017.

Fig 1: Pulling Out Rubber Mount With Special Tools (22 1 101), (33 4 465) And Nut (22 1 017)

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note

Arrow on rubber mount must point to arrow on housing.

Coat housing bore and rubber mount with Circolight, refer to BMW Parts Department.

Fig 2: Identifying Mark On Rubber Mount

Courtesy of BMW OF NORTH AMERICA, INC.

Insert special tool22 1 102 with bolt into recesses of rubber mount.

Fig 3: Inserting Special Tool (22 1 102) With Bolt Into Recesses Of Rubber Mount

Courtesy of BMW OF NORTH AMERICA, INC.

Draw in rubber mount with special tools 22 1 102/22 1 103/33 4 465 and 22 1 017.

Fig 4: Installing Rubber Mount With Special Tools (22 1 102), (22 1 103), (33 4 465) And (22 1 017)

Courtesy of BMW OF NORTH AMERICA, INC.