67 31 540 Removing and installing/replacing drive unit for head restraint adjustment (comfort seat)

WARNING: This page is about a different car, the 2011 BMW X6 and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove BOTH REAR PANELS ON FRONT SEAT BACKREST

Disconnect plug connection (1).

Release screw (2).

Tightening torque 67 31 4AZ .

Fig 1: Identifying Plug Connection And Mounting Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Pull shaft (1) in direction of arrow out of shaft receptacle (2).

Installation:

Make sure shaft (1) is correctly seated in receptacle (2).

Release retaining ring (3).

Feed out drive unit for backrest head adjustment (4) and remove.

Fig 2: Removing Backrest Head Adjustment Drive Unit

Courtesy of BMW OF NORTH AMERICA, INC.

Removal and installation only:

Do not turn spindle (1) in order not to change measurement A.

Replacement:

Adopt measurement A of removed drive unit for backrest head adjustment (2). If necessary, adjust measurement A by turning spindle (1).

INITIALIZE drive unit for backrest head adjustment.

Fig 3: Adjusting Back Rest Head Measurement

Courtesy of BMW OF NORTH AMERICA, INC.