51 47 128 Removing and installing/replacing trim panel for luggage compartment floor

WARNING: This page is about a different car, the 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

Push retaining spring (1) to end of gas pressure spring.

Remove gas pressure spring from ball head.

Firmly pull luggage compartment floor (2) towards rear and thereby disengage from hinges (3).

NOTE: Removal is easier the flatter the luggage compartment floor (2) is positioned.

Fig 1: Pushing Retaining Spring To End Of Gas Pressure Spring

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Remove HANDLE ON TRIM PANEL FOR LUGGAGE COMPARTMENT FLOOR .

Release screws (1).

Remove hinge (2).

Fig 2: Identifying Hinge And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Remove mounting plate (2).

Fig 3: Identifying Mounting Plate And Screws

Courtesy of BMW OF NORTH AMERICA, INC.