51 47 126 Replacing handle on panel for luggage compartment floor

WARNING: This page is about a different car, the 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

Release screws (1).

Separate both handle halves (3) from each other at catches (2).

Fig 1: Identifying Handle Halves, Catches And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Lever (2) and spring (5) on handle recess (1) must not be missing or damaged.

Removing lock cylinder:

Remove lever (2).

Release catches (4) and remove lock cylinder (3).

Fig 2: Identifying Lever, Spring, Handle Recess, Catches And Lock Cylinder

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Following parts on handle recess (1) must not be missing or damaged:

2 Fastener
3 Springs
4 Catches

Fig 3: Identifying Handle Recess, Fastener, Springs And Catches
Courtesy of BMW OF NORTH AMERICA, INC.