13 54 030 Removing and installing/sealing throttle assembly (M62)

WARNING: This page is about a different car, the 2003 BMW X5 and 2002 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

Switch off ignition.

Remove intake hose,

refer to 13 54 250 REPLACING INLET HOSE (BETWEEN MASS AIR FLOW SENSOR AND THROTTLE BODY) (M62) .

Disconnect plug (1).

Release screws (2).

Remove throttle assembly.

Fig 1: Removing Throttle Assembly

Courtesy of BMW OF NORTH AMERICA, INC.

Check sealing ring (3) on throttle assembly for correct seating and damage and replace if necessary.

Installation:

To assist installation, coat sealing ring (3) with anti-friction rubber coating (e.g. petroleum jelly).

Fig 2: Checking Sealing Ring On Throttle Assembly

Courtesy of BMW OF NORTH AMERICA, INC.

Check sealing ring (1) on throttle assembly (2) for damage and replace if necessary.