12 61 285 Removing and installing/replacing oil level sensor for engine oil (N63 hybrid)
WARNING: This page is about a different car, the 2011 BMW X6 and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
High-voltage system - danger to life!
WARNING:
The following points must be strictly observed prior to starting work:
- Observe SAFETY INFORMATION for handling with hybrid cars
IMPORTANT:
Read and comply with notes on protection against damage from electrostatic discharge (ESD protection).
Necessary preliminary tasks:
- Switch off ignition.
- Remove REINFORCEMENT PLATE .
- Drain ENGINE OIL .
Unlock connector (1) and remove.
Unscrew nuts (2).
Tightening torque 12 61 2AZ .
Remove oil level sensor (3).
Installation note:
Clean sealing surface on oil sump.
Replace seal on oil level sensor.
An excessively low torque value will result in oil leaks.
An excessively high torque value will result in damage to the oil level sensor.
Top up engine oil.