64 11 823 Replacing actuator drive for right rear passenger compartment air stratification flap

WARNING: This page is about a different car, the 2011 BMW X6 and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove FRONT FOOTWELL ACTUATOR DRIVE

Remove right side section housing (1).

Remove air duct (2).

Fig 1: Identifying Right Side Section Housing And Air Duct

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1).

Release screws (2) and remove servomotor (3).

Fig 2: Identifying Plug Connection, Servomotor And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Servomotors must be re-addressed in the event of replacement!

Addressing can only be carried out with the BMW diagnosis system.

Service functions:

Body
Heating and air conditioning function
Flap motors
Re-address flap motors