72 11 092 Removing and installing/replacing rear left or right seat belt
WARNING: This page is about a different car, the 2011 BMW X6 and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Remove REAR SEAT
- Remove PANEL FOR ROOF PILLAR
Installation:
- Microencapsulated screws (Loctite) must be replaced and may not be reused
- Screw connection must be completed within 20 minutes (start of curing)
- Microencapsulated screws must not be retightened
- Clean thread of nut beforehand in event of repeated use
Release screw (1) on anchor fitting.
Installation:
Replace screw.
Tightening torque: 72 11 21AZ .
Installation:
End fitting is coded against incorrect assembly.
Release screw (1).
Installation:
Replace screw.
Tightening torque: 72 11 20AZ .
Remove inertia reel mechanism (2).
Installation:
Automatic reel (2) is encoded against incorrect installation.